SLET Result, 2018 Declared, Check Your Result and Cut-off.

(adsbygoogle = window.adsbygoogle || []).push({});

This is notified that the following Roll Nos. appeared in SET, 2018 (held on 04-02-18) are declared pass in the Test and are Eligible for
Lectureship in Colleges and Universities of N. E. States including Sikkim.
The criteria adopted during the finalisation of the result is as follows:
It has been decided by the UGC that 6% of the appearing candidates should be declared qualified for Eligibility for Assistant Professor:


(adsbygoogle = window.adsbygoogle || []).push({});



 i) In order to be considered for eligibility for Assistant Professor, the candidates must have appeared in all the three papers
and secured at least 40% aggregate marks in all the three papers taken together for General Category candidates and at least 35% aggregate marks in all the three papers taken together for all candidates belonging to reserved categories, viz -SC, ST, OBC (belonging to Non Creamy Layer) and PWD 



 ii) The calculation is based on the ratio of number of candidates who secure minimum aggregate percentage of marks as
prescribed in (i) above in each subject category-wise to the total number of candidates of that category over all subjects
fulfilling (i) above multiplied by the total number of slots to be awarded to that category. The nearest whole number
obtained as per this formula-provides the number of slots available in any particular subject category-wise



iii) By this method, if the number of slots obtained is less than one, it is taken as one, i.e. a minimum of one slot is awarded wherever a fractions less than one is obtained as per the calculation. However for fractions greater than one, the figure is rounded off to the nrearest whole number.


iv) The aggregate percentage of all the three papers corresponding to the number of slots derived as per the previous paragraph is taken as the cut-off qualifying percentage marks for a particular subject category-wise.

(adsbygoogle = window.adsbygoogle || []).push({});